How To Cut The Lace Off A Frontal Wig

When you buy a new lace headcover, it usually has extra lace edges on the forehead. At this point, you won't be able to wear the wig outside, but you'll need to trim extra lace to make it look more natural. How to cut excess lace is a required course for you. Scissors, tweezers, clamps, etc. are all necessary tools. Of course, in addition to the tools, your patience is essential.

Generally, after you put the wig on, you cut off the excess lace in front of a mirror. It's easier to cut off the excess lace after you wear it, and you can always adjust the lace wig to fit your head.

These steps can be used as a reference:

1. Make sure your hair is smoothed and smoothed under the wig.

2. Wear a lace wig that matches your natural hairline.

3. Position the wig until it fits perfectly into your head.

4. Pull your hair back with bobby pins.

5. Cut off the ears. Part the hair with the sharp end of the comb, then secure it with a bobby pin, use scissors to cut the hair into the shape of the ears, then remove the tags.

6. Cut the lace into three pieces, starting at the center of the lace on the wig, then zigzag it until it reaches the end. Stay as close as possible to the hairline and don't cut any hair from the wig. When cutting lace, try to use the natural shape of your hairline as a guide. This step is important, so take some time and cut small pieces at a time until you've cut away all the extra lace. When cutting lace, be careful not to cut natural hair.

And, of course, many people like to remove the lace before wearing a wig. The first few steps are the same.

1. Start with a lace wig and make it fit perfectly on your head.

2. Make sure your hairline is flush with your natural hairline. This is the most important step.

      3.Cut the extra lace off the corner near the ear.

4. Place the ruler vertically on the edge of the lace. Starting with the left lace edge, use the pen to draw a dot 1/8 inch or 1/4 inch in front of the lace edge. If the lace starts to wear, it needs to be cut away, leaving extra length to prevent hairline loss.

      5.Connect the dots with a line.

6. Take off your wig. Put the lace front wig on a wig head and remove the loose strands from the pre-plucked lace wig.

7. Use scissors to cut the lace along the line you drew. Don't leave pen marks on the lace edges. There can only be about 2mm lace in front of the hairline.

When you start cutting extra lace, it's very important to measure the extra lace you need to cut, and you need to be very careful to adjust the wig so that it can fit perfectly into your head.